Available here: http://www.scca.com/assets/Prelimina...tes_v2b%20.pdf and here: http://www.scca.com/assets/Preliminary_December_TB.pdf
Dave
Available here: http://www.scca.com/assets/Prelimina...tes_v2b%20.pdf and here: http://www.scca.com/assets/Preliminary_December_TB.pdf
Dave
Thanks David... I think they got the displacement incorrect for the 2012 Honda Civic Si. It should 2.4, not 2.0.
Demetrius Mossaidis aka 'Mickey' #12 ITA NESCCA
'92 Honda Civic Si
STFU and "Then write a letter. www.crbscca.com"
2013 ITA NARRC Champion and I have not raced since.
You are correct. The displacement should be 2354 (that got shoved into the wheelbase which should be 2620/2670 (2dr, 4dr). It may be too late to fix that for the December Fastrack, but we'll get it the next time around. Thanks for noticing.
Dave
Full version up (and thread title adjusted accordingly...)
http://www.scca.com/assets/11-fastrack-dec.pdf
Rules passed for 2012:
#3193 – Add a new 9.1.3.D.9.n as follows: “Windshield washer systems, rear windshield wiper systems, cruise control systems, horns and the wiring associated wiring with any of these may be removed. Any holes left in the body must be covered or plugged.”
Wheel rules changed:
#3426 – In 9.1.3.D.7.a.1 change as follows:
Cars may not fit wheel diameters larger than those listed on their spec line. Knockoff/quickchange type wheels are prohibited. Wheels must be made of metal.
[All ITS/ITA/ITB/ITC cars currently listed in the ITCS with a wheel size less than 15 inches would be changed to 15 inches. All ITR cars currently listed in the ITCS with a wheel size less than 17 inches would be changed to 17 inches. The heading on the wheel size column would be changed to “Max Wheel Diameter”.]
#3749 - In 9.1.3.D.9.c, add the following at the end: “Switches to activate the ignition, the lights, the windshield wipers, the starter and other accessories located within the passenger compartment may be replaced and their location changed.”
(multiple) - In 9.1.3.D.1, add a new subsection s as follows: “To allow commonly available engine mount aftermarket inserts, replacement units, or “window weld” like solutions without allowing solid metal or rigid materials or bearings that could result in the driveline becoming a stressed member of the chassis, the following is permitted. Engine, transmission, differential or any other driveline mounts may be replaced. Mounts may use only stock mounting points, must maintain stock location and orientation of the mounted component, and must be non-rigid.Rubber or other inserts in stock mounts may be replaced with any other non-metallic material.”
In 9.1.3.D.2, add a new subsection e as follows: “Alternate mounts are permitted as in 9.1.3.D.1.s.”
Demetrius Mossaidis aka 'Mickey' #12 ITA NESCCA
'92 Honda Civic Si
STFU and "Then write a letter. www.crbscca.com"
2013 ITA NARRC Champion and I have not raced since.
Can we interpret 9.1.3.D.7.a.1 to mean that cars that are listed with 15" wheels can run 14" or 13" wheels?
Bill Stevens - Mbr # 103106
BnS Racing www.bnsracing.net
92 ITA Saturn
83 ITB Shelby Dodge Charger
Sponsors - Race-Keeper Data/Video Aquisition Systems www.race-keeper.com
Simpson Performance Products - simpsonraceproducts.com
APPLAUSE!!!! Chuck
Chuck Baader
White EP BMW M-Techniq
I may grow older, but I refuse to grow up!
Forgot Charcoal Cannisters...geez louise...
>> #3193 – Add a new 9.1.3.D.9.n as follows: “Windshield washer systems, rear windshield wiper systems, cruise control systems, horns and the wiring associated wiring with any of these may be removed. Any holes left in the body must be covered or plugged.”
>> Body – All parts of the car licked by the air stream and situated above the belly / floor with exception of the roll bar or cage. (GCR Technical Glossary)
That big hole resulting from removal of the washer bottle is going to let a lot of nice cool air in from inside the fender.
K
Damn.. waisted $50 bucks last year on one that I used for 3 races I didn't even realize it was up for a rule change. Oh well I need to lose some lbs so this helps
Stephen
interesting...
Chris Rallo "the kid"
-- "wrenching and racing" -- "will race for food!" -- "Onward and Upward"
Not IT related, but I find it interesting that they threw out the 2.5 participation rule yet again to save T3, but "the CRB has no intention of returning GP to the GCR"
Cool...
So after all the arguing, haranging, harassment and ridicule
for the damages of rules creep, we can now legally remove our windshield washer bottle and defunct horns and use custom, non rigid driveline mounts?
Ya know, we're all starting to look a lot like congress.
John W8
CSP10 Miata
ITA50 Miata
Best bunch of rule changes I've seen in a long time. I was just about to send in what I expected to be another no-hope request to allow deletion of washer bottles, and what happens? Thank you!!
Tom Lyttle
Decatur, GA
IT7 Mazda - 2006, 2008 SARRC Champion
ITS Nissan 200SX - finally running correctly
FP Ford Capri - waiting for a comp adjustment
GT3 Dodge Daytona - what was I thinking?
I don't like the motor mount rule.
I don't like the wheel rule.
I am ambivalent to the horns/washers/etc rule.
I would rather see the charcoal canister get addressed over all of these...
Bookmarks