Ok started looking around at parts. This is what I have so far

Engine Management:
AEM ems 1000 "had it chilling in my tool box"
AEM Widband guage and sensor "stole it and the cluster guage pod from my wifes car lol"
AEM Short Ram intake
OBD2 to OBD1 conv. harness
Walbro 255 pump

Maintance junk:
Gates raceing T-belt with new pump and pulley
new OE fuel filter
NGK V-power BKR7E-11 and blue wire set
New OE "Honda/TEC" Cap and Rotor
Radiator hoses and bulk replacemnt heater hose
Previously Tortured Fluidyne radiator

Engine Parts: "have not ordered any of this stuff yet going to drive on the street for a bit and get some stuff sorted"
JE 10:1 0.040" oversize Forged Pistons
Honda OEM Gasket kit
Honda OEM Oil Pump
Guides and Valves
ARP Head studs
Bearings "Will have to color code or just get generics"

Trans:
ACT Mod clutch disc with Heavy duty Presure Plate
New Release Bearing and Pilot Bearing
M-Factory LSD
"Will eventually get Carbon Syncros and a diffrent final drive ratio gear set"

Suspention"
ASR 23mm rear swaybar "Will upgrade to the 32mm if needed"
D2 coilovers "will have to get diffrent springs"
Enegery Suspention master kit and trailing arm bushings
MOOG replacement balljoints

Brake:
Russell S/S brake hoses
Hawk Blue front and rear pads
Integra RS brake hard lines and 40/40 prop valve "ABS Delete"
ATE Blue racing fluid


Ugg just looking at this stuff makes my knuckles hurt. Thankfully I have alot of the really Spendy stuff sitting around from my boss and my old Drag car days. Will post pics as soon as I get some time to get started on the suspention. Hopeing to do a few track days with the car before I get serious about the Cage/Seat mounting.

Any Suggestions on Springs, wheels and tires would be great! Thanks in Advance....