Title says it all.
Title says it all.
Steve Elicati
ITA 1994 Mazda Miata
Central Florida Region
At a glance, I would say no... but I don't have my GCR handy
Demetrius Mossaidis aka 'Mickey' #12 ITA NESCCA
'92 Honda Civic Si
STFU and "Then write a letter. www.crbscca.com"
2013 ITA NARRC Champion and I have not raced since.
Does sit higher than the bottom of the wheel rim?
Does it fit a stock bodied car, and is it covered in the vertical shadow of said body?
If the answers are yes, then yes.
No.
NOPE!!!!!! Its a Miata. Nothing Miata is legal!!!!!!!!!!
Mark
Montero Racing (CFR)
Plymouth Neon ITA (For Sale)
Dodge Daytona ITB (sold)
It appears too high, and as mentioned appears to not fit a stock bumper. Further, I think it closes the radiator opening, which IIRC, is a no no.
Jake Gulick
CarriageHouse Motorsports
for sale: 2003 Audi A4 Quattro, clean, serviced, dark green, auto, sunroof, tan leather with 75K miles.
IT-7 #57 RX-7 race car
Porsche 1973 911E street/fun car
BMW 2003 M3 cab, sun car.
GMC Sierra Tow Vehicle
New England Region
lateapex911(at)gmail(dot)com
It's not really a fair question. That is an EP or FP Miata it looks like. So it has alternate bodywork that the airdam meets flush to the body as well as an alternate nose piece that is throwing off the visual. So THAT unit would not be able to bolt up to an IT car legally because it woudn't meet the requirments in a variety of ways.
However, you COULD build one similar using the stock nose that went straight down. Mike at ISC has tried something similar.
ISC now sells this:
http://www.iscracing.net/miata_fiberglass.html
and it IS legal, and apparently works very well.
remember - no lower to the ground than the wheel rim, no higher on the car than 4in above the centerline of the front wheels at ride height. must not protrude beyond OE bodywork as viewed from above. cannot obscure factory grille opening.
thanks guys. a fiberglass version of the piece in the pic is for sale on the production website. until andy mentioned it i forgot that the production cars use different body panels. i didn't think it covered the stock grill opening and i figured i could trim the bottom if it was too low. my miata is on jack stands and i'm unable to measure from the center of the hub to the top of the bumper but it looks pretty close to 4 inches. either way it won't fit the contour of the stock body so i guess it's a no-go. too bad it would look bada## on my ita miata
Steve Elicati
ITA 1994 Mazda Miata
Central Florida Region
Bookmarks