Originally posted by dave parker@Nov 23 2005, 08:41 PM
One of my friends, against my advice, bought a Merkur XR4Ti. He needs motor mounts for it. Any suggestions on where to get these?

It is a street car. But I figured the ford racers might know this one.

Thanks
"dangerous" dave parker
wdcr ITC-> HP #97
[snapback]66496[/snapback]
They should be the same as the Mustang SVO 84-86 mount. I say should, because I know the fox chassis is slightly different from that chassis, but the transmission and engines are the same. If that does not work I would bet that the mounts from a Cosworth Sierra , sold in England, will be the same and those are readily available overseas. In fact, any 2.3L Mustang mounts might work because I don't know for certain that 2.3L NA have different mounts than the 2.3L Turbo engines.

You could also try the Thunderbird TurboCoupe mounts from 84-88 since the same engine and driveline are present there too.

Excellent little cars and can be made very fast. I used to have an 86 SVO and with about 22-25lbs of boost the little fellow could put down 310-320 at the wheel. More was easily obtainable with a cam swap, cheap and easy, and turbo upgrade to a T04E/50 compressor trim with T3 turbine. Hybrid setup. Go to a large Volvp front mount intercooler for cheap power and durability, plus, you can go to a large valve head too if you are inclined. www.corral.net is a good source, and I have seen some of the SVO mills making 420+ rwhp with $2.5k of investment. Bottom end are stout pieces, leave them along until they pop.