-
Miata Trunk Hinge Repair
My Miata was lightly hit from behind, but it bent the trunk hinges. I've got a new hinge assembly (brackets, hinges, torsion bars) and tried to replace it earlier today. There are two nuts on each end of the hinge assembly that are easy to get at and easy to remove. But the assembly wouldn't come out. So I look at the replacement hinge and notice a couple of nuts welded in way in the back. It seems there are bolts coming though those nuts from the back (the front of the car). Can anyone give me some advice on getting at them to swap the assembly? Or should I just break down the assembly and try to replace only the two hinges and keep the current brackets and torsion bars?
-
Sorry I can't help, but you might also try the Spec Miata forum if you haven't yet.
------------------
Marty Doane
ITS RX7 #13
CenDiv WMR
-
Thanks for the reminder, Marty. I'd forgotten about the Spec Miata boards.
-
Easy to do....but watch what you say! NEVER combine "censorship" and "JD" in the same sentence! Or you'll get edited, censored and deleted, then barred!
------------------
Jake Gulick
CarriageHouse Motorsports
ITA 57 RX-7
New England Region
[email protected]
-
Um, that went past me at about 100 mph, Jake.
-
Oh, duh, after two and a half hours I figured it out. Just ignore me. :-)
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks