-
Actually the $460 number is for the spool only without the bearings and bolt kit. I asked about this today and was going to post it here, but Bill was right on top of it.
Also for those wondering where the cost is in these peices, I asked about that last week...As you can imagine it is not the material, I mean steel is not THAT expensive. It turns out that the expensive part was the custom tooling for broaching the splines, and thus the machining is pretty pricy.
Chris
[This message has been edited by shwah (edited September 23, 2002).]
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks