Data acquisition is taking a lot of time due to wiring and setup of various devices. For example, on the GoPro camera with the Tmate the housing must be cut in numerous places to allow for the data cable, power cable, and the SD card to be removed and inserted.





The radio antenna was put in the stock location but I'm not sure how I like that or if it'll be optimal for functioning.



I've still got mucho wiring to do for getting signals into the Tmate but at least there is light at the end of the tunnel.

We're planning to have the green car up at the May VIR event, at least for the test day, so I've got to get the wiring knocked out before this weekend. Glass has to be installed on Thursday, oil leak fixed, then we've got to spend Sat aligning the car. Hopefully it'll be road worthy on Sunday so we can hit the streets and dyno tune it the following weekend.