I have heard.. not going to mention from whom.. but they got stock cams from supplier A.. then drilled there own dowl pin at the at teh degree that they found most beneificial within the stock range. Fortuantely for them the stock cams range was apparently failry broad. A fair stretch of the rules that if jsut left up to a degree wheel and dial gauge would be legal. The cams got protested, however the protested party was handed the portest then told to bring there car up tech. Since the messenger left, they were able to swap in stock cams before having to pull them again in tech. (there was a reason why the car didn't run to the tech shed.. the timing was WAY off.. they jsut threw the cams in there.. didn't have time set them up.)

Side note.. As a vote of relief this was not on a IT car.