This could be a dumb question but on the front down tubes on my roll cage there is a crimp where they were bent to go from the a-pillars to behind the dash. In the GCR it states that you cannot have any crimping on the main hoop but i'm not sure about these front down tubes. It doesn't look too safe to me so i'm assuming its no good but if I could get away without having to completely change the down tubes that would be great. It's a halo design cage if that matters any.
Also another question I'm having is about my turn signal/running lights. According to the regs any lights mounted on or below the bumper shall be removed. The car is a 93 Ford Probe and the turn signals are mounted at bumper level recessed in about an inch. Do I need to remove these or can I leave them since they are recessed into the bumper?
Roll cage bad bend?
Reply With Quote
Bookmarks