-
GCR Page 295
"...Weber carburetor(s) with swaged fuel inlet fitting shall be replaced by drilling and tapping the carburetor body for a threaded fitting."
Does this mean that specificaaly an AN- fitting must be used? or can a barbed NPT (same fitting on the fuel pump) be screwed into the carb and fuel line clamped to it?
My carb has the stock brass inlet, I assume this is the swaged inlet referred to in the rule.
Thanks,
Todd
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks