Quote Originally Posted by Chip42 View Post
how is your splitter mounted? we use a "L" shaped bracket bolted to transport tie-down locations on the bumper horns, the bottom of which has a slot at the front, opening to the rear, and a pin hole at the back. the splitter plate has mounts which capture the brackets in double shear, so the slotted mount "hole" never has to come undone. use a small bolt for the fixed mount and a 3/8" or so up front. one mount on each side. if you hit something, the rear pin shears and the splitter falls off, most if not completely intact. make it from good plywood covered in a thin layer of GFPR for toughness.
Do you have any pics you'd be willing to share? My methods sound somewhat similar, but I've not yet figured out how accomplish the graceful departure.

What's GFPR?