Used standard bore is the best for me. The block is 2.5 over so I am set up for stockers. Thanks, How much?
When I hurt this block I will go with the 2.0.
The next Chumper may have one Buick V6/Caddy Northstar, etc in the back of the Mk 3 Jetta.
Senior Member
Used standard bore is the best for me. The block is 2.5 over so I am set up for stockers. Thanks, How much?
When I hurt this block I will go with the 2.0.
The next Chumper may have one Buick V6/Caddy Northstar, etc in the back of the Mk 3 Jetta.
Mike Ogren , FWDracingguide.com, 352.4288.983 ,http://www.ogren-engineering.com/
Member
Mike, I have a set of STD 1.8 JH pistons, clean with new rings installed. I changed them out to 10:1 and they only have been hand turned on the engine stand. I can make a deal for them in exchange for one of your prep guides.
Tom Broring
Wash DC Region
ITA Nissan Sentra SER
HP Triumph Spitfire
HP VW Rabbit
Senior Member
Done. Send me an mail . addy below
I'll send it off .
Thanks a lot. MM
Mike Ogren , FWDracingguide.com, 352.4288.983 ,http://www.ogren-engineering.com/
Posting Permissions
Reply With Quote
Bookmarks