Yes they could. Just make sure they know what they are doing and use the proper machines. Otherwise it will warp and the gear will not mesh properly. Ring gears are hardened to rc 58-60 or so I hear.
Yes they could. Just make sure they know what they are doing and use the proper machines. Otherwise it will warp and the gear will not mesh properly. Ring gears are hardened to rc 58-60 or so I hear.
Last edited by seckerich; 04-12-2013 at 12:45 PM.
Steve Eckerich
ITS 18 Speedsource RX7
ITR RX8 (under construction)
Bookmarks