Currently have the Bildon 60mm screw in wheel studs installed but last race wasn't able to get proper torque on 3 lug nuts on the rear of my car, which leads me to believe they are pulling out. I want to fix that prior to next race.
What press in studs are you using? I would like to keep the same M12x1.5 thread since the front hubs are new and the screw in studs are holding for now and don't want two different sets of lug nuts.
Jegs lists M12x1.5, 2 1/2" long wheel studs that fit late model Camaro/Firebirds and Corvette. Would these work?
Any other tricks that I could try to keep the current ones from pulling out? I have drums, so don't believe welding would work.
Center punching the back side to make the material wider?