Part Five
I put rivnuts into the steel floor to mount the cooler. Then I drilled down through the cooler and attach the unit that way. So that the bolts don't become heat sinks I bond foam and silicone over the top of them (not done yet) to insulate them from the ice water.
It was a difficult thing to work in the trunk area for the wiring and plumbing of the fire bottle and cooler system.
You can see the bolt heads and the sealing silicone in the bottom of the unit.
And, tada, all done.
Now, if you think about it ahead of time you can properly position that spigot on the side so you can drain the water out of it. All I have to to is pull up that rubber connector seal, push the button, and the water will drain out through the bottom of the car.
Reply With Quote
Bookmarks