Brings back so many memories....
End result is a bag of black tar and foam seam sealant that weighs 5 lbs.
Best thing to remove the tar? A pneumatic gasket scraper, takes the tar paper off like warm butter and doesnt damage the sheet metal underneath. Hence the name gasket scraper, if itll work on an oil pan then it wont damage sheet metal. Watch out on aluminum cause the blade will go right through aluminum too. Finish off the job with a cup brush on an electric grinder.
http://www.bing.com/shopping/search?...aper&FORM=HURE
This was my first build, first time taking this shit off and I figure out a better way that doesnt involve a torch, dry ice or hand held scrapers. Better lucky than good. Give the pneumatic gasket scraper a shot it works!!
Reply With Quote
Bookmarks