Currently have GAB shocks/struts on car and feel they may be getting tired. I don't know if these are still available? The have multiple adjustments. Anyhow looking for replacements. Thanks T Weaver
Currently have GAB shocks/struts on car and feel they may be getting tired. I don't know if these are still available? The have multiple adjustments. Anyhow looking for replacements. Thanks T Weaver
Tom Weaver: Logistics & Technical Support Manager IE truck driver for 1986 RX-7 ITS #63. "Diesel Haulin' Rotary" 2005 Dodge 2500 Quad Cab The Hemi has retired "Long Live the Hemi" Bill Weaver Driver- 2004 NYSRRC John Chave Award. 2006 & 2013 ITS NYSRRC Champion!. Truck Driver Named Glen Region Worker of the Year 2008.Located 45 miles southeast of Watkins Glen in Sayre PA.
KYB AGX's are the same thing as your old GAB's , check ebay, probably around $450 will do the car.
matt
Tom Weaver: Logistics & Technical Support Manager IE truck driver for 1986 RX-7 ITS #63. "Diesel Haulin' Rotary" 2005 Dodge 2500 Quad Cab The Hemi has retired "Long Live the Hemi" Bill Weaver Driver- 2004 NYSRRC John Chave Award. 2006 & 2013 ITS NYSRRC Champion!. Truck Driver Named Glen Region Worker of the Year 2008.Located 45 miles southeast of Watkins Glen in Sayre PA.
The fronts should have 4 different positions on the top and the rears have a knob on the side under the car that you can set 1-8
matt
Well the rear shocks are on direct replacement. The fronts are different story. The strut bearing does not fit the new shocks . on the old struts apparently what was done was to grind the rod to fit the bearings as mounted in the plates. Headed to a local bearings unlimited store to see what I can come up with. T W
Tom Weaver: Logistics & Technical Support Manager IE truck driver for 1986 RX-7 ITS #63. "Diesel Haulin' Rotary" 2005 Dodge 2500 Quad Cab The Hemi has retired "Long Live the Hemi" Bill Weaver Driver- 2004 NYSRRC John Chave Award. 2006 & 2013 ITS NYSRRC Champion!. Truck Driver Named Glen Region Worker of the Year 2008.Located 45 miles southeast of Watkins Glen in Sayre PA.
What is the diameter of the new strut? I do remember them being turned down by Ground Control to fit my GC camber plates. It would pobably be easier to have a local machine shop turn the new shafts down if they are greater than 5/8".
matt
Bookmarks