That's what I was thinking. Just getting it bored over and getting a piston kit. Do you know of a machine shop in Lincoln or Omaha that has a torque plate for our motors?
That's what I was thinking. Just getting it bored over and getting a piston kit. Do you know of a machine shop in Lincoln or Omaha that has a torque plate for our motors?
Ralf
ITB Golf GT
Torque plate no i don't....I have a machine shop near my shop that may be willing to make one due to the fact that I am already building one JH....Two-three.....1.8s....
We can make one fairly easy....1/2-3/4 inch plate and a mill.....
I have been building 2-3 VW engines a year.....Most Machine shops around here suck for small bore stuff......Line boring & 1.8T stuff is almost impossible in Nebraska...
I am trying a new (6th) shop for machine, Corvettes unlimited.... Gesford in Hastings will do almost anything with SCCA/NASA involved, George is a good guy, he needs us to race MPH!
______________
Waterhaus Racing is Back!
NRSCCA Competition Chair
BOG Member
"Nebraska organizing committees
to race in Iowa & Ne board thing "
Still working on a name...
X-MVRG Member...
ITB Rabbit/ITA Miata
Your correct about availability ,last year i could only get.20 over not .40 in 9.0 .My engine builder said to be legal not to use 10.0 .Did he read that wrong?(update/backdate)!? At least i can bore it again ,unless i vent the block.
We have a .5 comp increase & 1.2mm over bore......Ya try and find any cast vw pistons 1mm over!!!! I have never seen them....in 20 years....there is few .25mm(.010)& lots of .50mm(.025in)
In a MK2 golf 8v if you have all the GTI stuff(rear disk), you can run 10.5:1 comp......If you have drums its 8.5:1..????.....????? may be a few more differences....Vented front rotors???? 9A gear box....
Last edited by Lael Cleland; 12-20-2009 at 09:32 PM. Reason: I forgot
______________
Waterhaus Racing is Back!
NRSCCA Competition Chair
BOG Member
"Nebraska organizing committees
to race in Iowa & Ne board thing "
Still working on a name...
X-MVRG Member...
ITB Rabbit/ITA Miata
My Golf GT came with non vented front brakes and rear drums but with the 10:1 RD engine and 9A tranny. According to the car classification, GTI, GT and GL are all on the same line allowing 10:1 compression.
Ralf
ITB Golf GT
WAHOO!!!!! 10.5:1 after the race is allowable!Are you running solid rotors now? I heard Hawk quit making pads......
______________
Waterhaus Racing is Back!
NRSCCA Competition Chair
BOG Member
"Nebraska organizing committees
to race in Iowa & Ne board thing "
Still working on a name...
X-MVRG Member...
ITB Rabbit/ITA Miata
Bildon sells 1mm over Pistons:
http://www.bildon.com/catalog/Detail...av=6&SubNav=62
Bookmarks