Any pics?
Any pics?
Scott Rhea
Izzy's Custom Cages
It's not what you build... It's how you build it
Performance Driven LLC
Neon Racing Springs
Love to if I could figure out how. Pic has to be hosted somewhere, right?
http://www.improvedtouring.com/galle...php?i=295&c=12
Maybe this works....
Last edited by Streetwise guy; 07-02-2009 at 12:30 AM. Reason: adding link to pic.
Jim Barnsley, Streetwise Service
WCMA IT2 Neon Twincam
2009/2010 Regional and Alberta IT2 Champion
2009 Regional Overall Champion. Second this year, dammit.
The acr hubs I just changed out had over 25 hours of w2w track time. Thing alot of it has to do with what type of tracks you run and car setup.
1987 ITS RX-7
2014 Ford Focus ST
Currently borrowing tow vehicles!!
Central Carolina Region
STEELERS SIX PACK!!
I experience a hub failure this year at Sebring and my hubs only had approximately 10 hours on them, when it failed it snapped the axle and luckly the wheel did not exit the car before I got it stopped. After being put on a flat bed and brought back into the pits upon jacking the car the whole wheel assembly fell off. What Chris Childs told me was to check the torque on your hubs every session for two or three times and them make it pre race weekend check. The hub tends to back off and allows to much slack. But yes you need to change these every 12 hours of track time to be safe.
Darryl Pritchett
ITA #92 Dodge Neon
2008 SE DP Champion
2010 CFL Region ITA Champion
The ACR hubs are on national backorder up here- there was 7 on b.o. this morning when I phoned my dealership, now there is 11, since I run a Neon ministock too. If they don't show in a couple of weeks I may have to start beating the bushes for a source. Any suggestions?
Jim Barnsley, Streetwise Service
WCMA IT2 Neon Twincam
2009/2010 Regional and Alberta IT2 Champion
2009 Regional Overall Champion. Second this year, dammit.
1987 ITS RX-7
2014 Ford Focus ST
Currently borrowing tow vehicles!!
Central Carolina Region
STEELERS SIX PACK!!
Napa is a block from my shop. I shall inspect, and look for "Made in China" signs. Thanks!
Jim Barnsley, Streetwise Service
WCMA IT2 Neon Twincam
2009/2010 Regional and Alberta IT2 Champion
2009 Regional Overall Champion. Second this year, dammit.
Bookmarks