Got mine last night, very nice. Although not enought to impress my wife or daughters, maybe if it had an MP3 player on it or something!!!
Very nice part, can't wait to put it on my car and make vroom sounds!!
Mike
Got mine last night, very nice. Although not enought to impress my wife or daughters, maybe if it had an MP3 player on it or something!!!
Very nice part, can't wait to put it on my car and make vroom sounds!!
Mike
Glad you like it!!
One fellow asked about harmonic dampening and would this piece cause an issue in the regards. The two engine guys I've talked to about it, one of course being a well-known L series builder, Sam, and the other a very good V8 builder that machines my L series stuff for me, think no.
The stock piece is one hunk of metal and is heavier than this piece. However, race engine builders routinely fight on both ends of the crank (dampener, clutch, flyhweel, pressure plate) to reduce weight and have no ill effects. If the L series engine was going to be hurt by a reduction in crank pulley weight you'd also think it'd get hurt by a reduction in flywheel, pressure plate, and clutch weight. I dropped five pounds off my pressure plate and 1.5 pounds off my clutch, the sum total being much more than the difference in this piece from stock.
It is certainly a use at your own risk part but I think it is fine. The motor I have wearing one now has about 8 to 10 hours on it (one ECR, three SAARCs, plus associated practice and qualifiying for each) and seems to have no ill effects. Runs like a champ. The new motor Sam Neave is building for me is going to wear one also.
Ron
Just as an update - my motor now has a tad over 26 hours on it with this dampener and seems to be going strong. No leaks, no vibrations, things seem ok. Now I know that we'd have to pull it apart to really tell what is going on with the crank and bearings, but thus far the motor is still kicking.
Ron
hi ron...new to this site...focused mainly on gt racing..i'd like to try one of these on my 260z vintage engine...don't know if you have any left or if your going to make any more????,please let me know...e-mail is [email protected] thanks..Bill
Hi Bill,
I might have one more in my race trailer. I'll check this weekend. I think I remember holding one back as a spare but since my prototype is still working just fine I can use it as a spare.
Ron
ok..yea i would take two (2) but i guess your out of them????i will use the one you have on my vintage 260z engine...i was going to use nissan comp dampener (euro),or a spare crankfire equiped one from the 70's they were bullitproof...i have them on my GTU/GT-2 280ZX tube car....and on my GTU/GT-2 300ZX tube car...but i'd like to try one of these....i have a pay-pal account which we can use for payment or i can send check,it's up to you...anyways thanks for getting back to me asap..i look forward to hearing from you..,hope you can find one in your trailer...Bill Erdman
I have one of the pulleys left. I emailed Bill but got no response. So it is up for grabs.
Thanks,
Ron
Bookmarks