I'm almost complete on the changes to my ITA Rx7 except for the rear lower links. Currently I still have the stock parts.

In theory they look like they would be very simple to make; steel tubing of the correct size and length, one left and one right rod end on each end. Install and adjust.

But theory and practice aren't always the same thing. What tubing will I need and where am I likely to find it? Can I use the stock parts and just cut off the ends?

Rod ends should be a straightforward purchase from Pegasus or Summit. I assume I'm going to need the "good" ones to tolerate the loads. I.E. expensive.

Any other tips? Or better yet, anybody got some for sale, cheap?

-chuck-