Warning Light sending units

[Sandro]

Busy wiring my dash and I would like to have a Warning light for water and oil temp when they reach a certain temperature. Longacre and other companies sell these for NPT threads but I am unable to find anyone that has them in metric. I could get a larger NPT one and just retap the threads in the mounting location but Im sure someone makes them in metric. Anyone know where I could find them???

Thanks

[JohnRW]

Pegasus Racing sells adapters.

[Sandro]

only problem is those adapters have a very small through hole, and the sender has the part that needs to go through



I would need one that looks like this.

[Dave Zaslow]

Take a look here:

http://egauges.com/

They have been helpful.

DZ

[Sandro]

thats where I bought all my gauges from and other senders but they only have the ones for warning lights in NPT

[Dave Zaslow]

Sandro,

These would allow you to use the 1/8" NPT:

http://www.egauges.com/vdo_acce.asp?Subgro...shings&Manf=All

They have a few more under the ISSPRO listing.

Hope this helps.

DZ

[GT240sx]

I don't know if you have the same issue I had, but I know I screwed up a fitting just like that blue one you posted. On my toyota, I thought the threads were metric, but they were actually npt, the difference was that the tap was not run in very far at the factory. I just purchased a npt tap and ran it in a good bit further and then the water temp sending unit fit perfectly.

[Sandro]

Dave,

thanks, those will work. Dont know how I missed them.


Gt240sx,

Im going to try that on an old housing I have before I buy the above items.`

Thanks guys !