New here but have been reading for months.

I have an ITB Rabbit GTI with a kinked metal fuel line where it turns a 90 up into the engine bay. Can I replace that section with a brass 90' fitting? I was going to flair the ends of the line and fix just that section.

Am I looking at a total fuel line replacement? Would a universal line from NAPA do the trick or can I replace it with stainless braded line? For those not familiar, this line runs under the car from the gas tank to the engine bay - turns up at a 90 degree angle - and then up behind the motor to the drivers side fuel distributor.

Thanks for posting.