I know this topic was already asked, but now that the season is coming to a close how did the weight reduction help the 944. Or is it still to soon to tell?
I am starting the tear down on the 944 and any help/suggestions would be helpfull.
Thanks
I know this topic was already asked, but now that the season is coming to a close how did the weight reduction help the 944. Or is it still to soon to tell?
I am starting the tear down on the 944 and any help/suggestions would be helpfull.
Thanks
I think it's too soon to tell but judging by the uproar some of the SM guys are making over an additional 25lbs, I think you will be a happy camper. Only downside? Big money to prep the engine to the level you need to to take full advantage.
I very highly doubt that any 944NA racers are able to come even close to the weight as it stands right now - I suspect that you could make the minimum weight 1,000 pounds and it wouldn't make any difference.
When I look at my lap times in my 944 8V, compared to the mylaps times for ITA - we would be a good solid mid-pack racer in ITA with the 8V 944 - I'm going to cite the times and write you guys a letter...
Chris Camadella
ITS Porsche 944
Make sure you site them for the same year...and remember, you were ta 2715 on old technology with 3 years of missing development.When I look at my lap times in my 944 8V, compared to the mylaps times for ITA - we would be a good solid mid-pack racer in ITA with the 8V 944 - I'm going to cite the times and write you guys a letter...
[/b]
Lap times are not evidence appropriate to support reclassification or consideration under PCAs. Any letter moving forward from the proposition that this IS the case should be returned with a note indiciating as such.
Make a case based on the mechanical attributes of the car and ONLY the attributes of the car.
PLEASE make an effort to understand how the Production and GT categories got into their current state. We can learn from history.
K
The 944 8V is a tweener. 158 stock hp. Yes, we know an ultra-prepped motor with programmabe ECU can only make about 20% over stock.
So it's too light in ITS (at 2575) or around 2900 in ITA. Remember, the 2S13 140hp 240SX (same displacement, same config and 18 less stock hp) is 2630.
What to do?
I agree that the 9448V is sort of a 'tweener'. It's too light at 2575 for ITS. I couldn't have, even if I went on a 25lb diet (which I could use) made the car, with no fuel, weigh less than 2665, which is 90lbs heavy. So, as I said, you could set the weight at ANYTHING, and it wouldn't make any difference. And this was a car that was completely stripped to the bare body shell of all extra undercoating, etc.
I therefore think that there is no way for this car (the 8V version) to be competitive in ITS in any sort of trim. Although I understand your argument about the 3 or so years of development - I'm not sure how valid that is in our case. We haven't any chassis gains (that I know of) in that time, and we actually lost some gains by having to switch to the less adjustable shocks.
Also, I'm not sure why it's completely invalid to cite the lap times. They are a good representation of how fast a well-prepared version can go at various race tracks, and I have good reliable data from a large variety of race tracks.
One of the things I don't understand is how the RX-7s just go faster and faster - I understand why ITS is faster - we now have the BMW's, the 944 got a 16v engine, and the Corrado V6 has lots of power as well. Is there that much development available in the RX-7's that they just keep going faster and faster to keep up, with no changes to the cars or the rules? But now, I'm off topic...
Cheers
Chris Camadella
ITS Porsche 944
Although I understand your argument about the 3 or so years of development - I'm not sure how valid that is in our case. We haven't any chassis gains (that I know of) in that time, and we actually lost some gains by having to switch to the less adjustable shocks.
One of the things I don't understand is how the RX-7s just go faster and faster - I understand why ITS is faster - we now have the BMW's, the 944 got a 16v engine, and the Corrado V6 has lots of power as well. Is there that much development available in the RX-7's that they just keep going faster and faster to keep up, with no changes to the cars or the rules? But now, I'm off topic...
Cheers [/b]
I think you prove my point there. No additional allowances yet cars are going faster. Shocks, new tire compounds, continuous searces for every last hp and countless hours on the dyno, 5 test days a year - not just to 'drive around' but to maximize a shock/spring/bar/alignment package for EACH track...continous development.
It's not about the 944 particularly but there's just no way to isolate the make/model/weight of the car, as a factor contributing to lap time. I could complain that the MkIII Golf needs a break based on my lap times but I'll bet my case would go out the window if a Cunningham or Pobst drove it at the ARRC....Also, I'm not sure why it's completely invalid to cite the lap times. They are a good representation of how fast a well-prepared version can go at various race tracks, and I have good reliable data from a large variety of race tracks. ...
[/b]
Testing and tire budgets, engineering skill and other factors contribute more than the basics of the platform. How about legality? Unless all of the subjects in the study get a thorough teardown, there's no way to know that we're comparing top-notch but legal cars.
Sorry. It's never going to make sound methodological sense to compare lap times, even if people have strong feelings about them as "proof" that a car needs a break. Or more lead.
K
EDIT - re: "it's a shame," there's absolutely no reason that one of the Porsche options in ITR, if a full-boat example were built, can't be competitive there. Part of the problem is that the level of performance of the Porsche product line is out of line with the whole IT category structure. Until now.
Chris,I agree that the 9448V is sort of a 'tweener'. It's too light at 2575 for ITS. I couldn't have, even if I went on a 25lb diet (which I could use) made the car, with no fuel, weigh less than 2665, which is 90lbs heavy. So, as I said, you could set the weight at ANYTHING, and it wouldn't make any difference. And this was a car that was completely stripped to the bare body shell of all extra undercoating, etc.[/b]
I am not up on all the IT rules, but I run 944 NASA 944 spec. In this class we can strip out just about everything that does not make the car go, but we keep stock steel body & stock glass. My car with me in it runs 2633 with a passenger's seat and 40lbs of ballast. I still have all my under coatings and I weight 165 with full gear. I still have few things I can remove to get below 2600 with ease and can get close to 2575 if I look for a few more things. This on an 84 chassis, but I am not 100% certain out stripping rules are the same. Our 944 spec class has some 100+ 944 2.5L 8v cars being raced or built for the class and the 2600lbs seems fair. Although latter chassis seem to simply weight more than the 83-85 chassis.
So while 2575 is pretty light I'd bet a number of 944-spec prepared cars can make this weight.
As for hp our rules geared torward stock hp vs expecting a 20% gain. Most of our cars Dyno to 130's RWHP so no where near the 148 expect for ITS cars so would be dog slow even if we get close to min weight.
Joe P.
Porsche 944 Racer
And I should point out that this from a guy everybody agrees preps cars to 100% and drives 10/10ths and I think JME builds his enginesI agree that the 9448V is sort of a 'tweener'. It's too light at 2575 for ITS. I couldn't have, even if I went on a 25lb diet (which I could use) made the car, with no fuel, weigh less than 2665, which is 90lbs heavy. So, as I said, you could set the weight at ANYTHING, and it wouldn't make any difference. And this was a car that was completely stripped to the bare body shell of all extra undercoating, etc.
[/b]
Fred Alphin
"Big leisure money seeker"
#92 Hankook Tire soon to be ITB? ITA?
Damn economy...
NO slam here on anyone but Phone dial wheels I understand are about 22lbs each? I believe that 40lbs could be shaved off Chris's car in wheels alone. And if this is truely an 944S it is on the heavier chassis is it not?And I should point out that this from a guy everybody agrees preps cars to 100% and drives 10/10ths and I think JME builds his engines
[/b]
Andy, Again I think you misrepressent my position a little bit. I think this car has not been given the time at the new weight to see enough competitive models built to truely determine the car can't make weight. The difference in the early and late cars is not exclusive to the 944.
GTL Nissan Sentra
DP 240sx
Vintage BS 510
ITS 240z
I just type like a pompous ass!
http://www.saveclubracing.com
Sorry, wrong on both counts. 15x7 phonedials are more like 15 lbs - only a few heavier than the Fuchs.NO slam here on anyone but Phone dial wheels I understand are about 22lbs each? I believe that 40lbs could be shaved off Chris's car in wheels alone. And if this is truely an 944S it is on the heavier chassis is it not?
[/b]
Chris's quote clearly indicates that he's talking about his (old) 8V; the 944S is a 16V car, and what he is now running, in my understanding. Not sure why this is still unclear.
I do have to agree with this; I cannot help but wonder if just 1 year is sufficient to see results!Andy, Again I think you misrepressent my position a little bit. I think this car has not been given the time at the new weight to see enough competitive models built to truely determine the car can't make weight. The difference in the early and late cars is not exclusive to the 944.
[/b]
I decided on the 944 for several season; first was the weight break it recieved; second was the diversity of clubs it can be raced in and the cool factor. I do not want to play follow the leader or have to race a mazda to be competitive in a cookie cutter class.
The Porsche 944 is a 20 + year old car with old technology(8v). The hp gains are there but the ITCS rules restrict it. My question is why? If you want more numbers open it up or dropt the 944 to ITA and add weight as needed. I know there are alot of PCA members that would jump in a heart beat. NASA leaders said that they want the 944Cup to have 60 cars for their next nationals.
It's a slame that one of the oldest sports cars manufactures isn't currently competitive in the largest SPORTS CAR CLUB.
Well ITR has plenty of good Por-sha choices, ITS has the 944 (untested at it's new weight) the 944S which has won plenty of races...and the 924 which has won in ITB...It's a shame (edit sp - A that one of the oldest sports cars manufactures isn't currently competitive in the largest SPORTS CAR CLUB. [/b]
Z cars are THIRTY year old technology, with far worse brakes, and less stock hp running near the front of the pack at the ARRC.
NC Region
1980 ITS Triumph TR8
Throw some weight on it and let it run in ITA, seems the logical choice to me. I'd rather drop down a class to be competitive with ballast than stay in a higher class, unable to shed weight, and lucky to just stay on the same lap as Moser... oh, wait, that is me!!! :P
PS - hate to have to remind a fellow P-car guy of this, but I'm a whole more likely to listen when Chris C or others who've spent a long time working with their cars expressing concern about being competitive, vs. someone who's just starting a build... Spend 5 years building it to the hilt and debugging it, then we'll have something to talk about. BTDT.
I think if the car could make minimum weight you would have a good fight on your hands. 2575lbs with 175-185 hp is quite nice, I just have no idea how anybody will get there. My old 8v looked like it was left out on the Cross Bronx Expressway for a night and I was still at 2720 with no fuel ( i do weigh 200lbs). Maybe a female driver at 98lbs, with a bare minumum roll cage, no accusump, smallest fire ex ......could do it. Looking forward to seeing somebody try. Russ
Russ is that wheel or crank hp?
I'm at 160 whp and 2560, and other than aero issues above 100 mph do not feel down on power to the fast cars. I would think 175-180 at the crank at 2575 with that handling and those brakes should be pretty stout, especially on momentum tracks.
NC Region
1980 ITS Triumph TR8
That would be crank per Milledge Engineering. Jeff, Im saying the car would work with the numbers. If you have 160 rwh, I think you'll be quite happy.
Bookmarks