-
Fuel Cell Installation Help Needed
I am attempting to install a "Fuel Safe" 15 gallon cell in my ITA 1st generation RX7. Underneath the rear of the car I have recently installed the "G-Force" panhard set-up and I have 3in. exhaust begining prior to the axle to the muffler. It seems like a tight fit. I would greatly appreciate help with the following questions:
1. Should I cut a large square hole from the trunk deck and drop the cell in from above? Or, should I cut an oblong hole in the spare tire well and mount it to the bottom?
2. I have already constructed a frame from L channel that fits around the corners. What is a good method to attach the cell to the car and build a bulkhead per SCCA rules?
3. I would like to run the steel braided fuel lines close to the stock location. Is this the best way?
Any help or suggestions are greatly appreciated. Thank you.
Bill Emery
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks