I've installed my TriLink set-up, but every time I look at the Differential Housing mount, I can't help but feel it should have some additional structural strength or support. I butt welded the entire outside edge where it contacts the housing, and about half of the inside edge. It seems solid, but I want to make sure it doesn't rip off under hard cornering loads (gulp!). Maybe its just my less than perfect welding technique I don't trust!

Has anyone had any problems with this or did any of you add some additional support? I was thinking about trying to form (to the curve of the diff housing) an L shaped bracket to support each side, and/or adding a piece of metal at the back end across both vertical pieces.
Thoughts?