Anybody run an MSD 6AL? I am about to put an MSD 6AL on to my Jetta. Currently I'm using a 2.0l 8v cross-flow engine, mikuni PHH dual sidedraft carbs, and the basic OE ignition. When wiring up the MSD, they supply these little isolator blocks to mount on the the coil, to facilitate installation, also allowing the MSD to be removed by jumping across the isolator block in an emergency... I was wondering if anybody has a MSD installed and wired up the system so that the MSD can be removed from the ignition system by the flick of a switch. I'm thinking about using 4 30amp 5pin relays. so that, when normally open, and unpowered, the relays would bypass the MSD, and when powered, the relays would provide the appropriate electron path so that the MSD signals the coil for spark. Any suggestions?