2door 325e roller, includes repaired rust holes in floor.
Hanover PA area.
Bring your trailer.
Type: Posts; User: mel horn
2door 325e roller, includes repaired rust holes in floor.
Hanover PA area.
Bring your trailer.
Whoops, it's an 85 E30. Sorry.
Also, I found out that the rear end in the proposed donor car is bad so it doesn't matter what ratio it is. (And the guy pulled the motor/trans and is sticking in a...
I have one of those special "Zundfolge 1324" motors in my 2002.
What rear end ratio should be in a 325i Automatic? 3.90 or 4.10?
(I suppose I could look at the tag but it's too hostile yet to crawl under a car. MAybe in a couple weeks...)
For that matter I...
(It's for a tow vehicle motor)
There was a show on Speed last week dealing with rebuilding an engine...I couldn't hang on and watch the entire thing but they mentioned "bronze titanium Coatings" for engine and gearbox.
Coatings...
Tim: Thanks ever so much, at the present time I am out of room for cars and my garage got flooded from Ivan, with a 2002 and two E30s inside. All were stripped, and the 325s were awaiting cages,...
Thanks so much.
Anybody know what rear is supposed to be in a 318i ? Car is approx an 85.
Thanks
...Actually I went over to the Ground Control site and looked at their setup, it seems that their tube is a lot shorter than the tube I have. Any feedback will still be appreciated. Thanks.
I'm preparing a '87 325. I'm going to install front coilovers, and have removed the spring perches. I've ground down the part where the perch was welded to the strut tube and a very small ridge...