PM sent
Type: Posts; User: cherbi7
PM sent
Where would be the best place to locate those? Just ask guys in my area? (St. Louis) I have checked some other sites and just do not see much on used tires that will work. Thanks
I am not too sure about what tire I should use and unfortunately I do not have the budget to spend a ton of money on tires. Has anyone tried the Nitto NT-01 225/45ZR-15 87Z BLK? (approx. $140) Or are...
If you need a list of all the dumb newbie questions for a possible pamphlet I have plenty of them. I think this is a great idea and could be very beneficial to us new guys.
What is a good starter tire? I know nothing about the tires out there for this car. If someone could point me in the general direction on a good compound or brand. I cannot spend a fortune so I guess...
I was also thinking about drilling a small hole and installing a zert fitting in the rear bushings to keep them lubed up. Has anyone done this or is it just overkill?
1986 Rx-7
I went to install the Lower A-arm busings which I bought from MMR-Direct. They seem to be very tight and I do not want to force them on and crack them. My question is should I heat them...
1986 Rx-7 ITS
I am nearing the finish of my build and have a couple of loose ends to tie up. The biggest issue is that I am looking to get a set of Delrin bushings but I am having a hard time...
I have heard about the S5 setup and it is a good idea to change over to it but then I have to change my engine wiring harness and AFM to be in compliance with the rules right? I think something with...
1986 rx-7
Can you remove the cold start thing on the motor? I have searched and cannot find anything on this...(is this considered emissions stuff?) If I can I know I have to plug some vaccuum lines...
Tried to contact you Matt kept getting my emails back though.
Thanks
Charlie
[email protected]
Are there any books or anything to go by too? I do not know much about the theory behind it and hopefully I can get everything set at a good starting point.
thanks again,
charlie
P.S. the car...
I have a 1986 Rx-7 just put the cage in was was going to move onto suspension. All of the numbers are mazdaspeed. Any information is greatly appreciated!
I am new to road racing and am lost on what to do with the suspension. I am on a strict budget and cannot spend a lot of money. I have been looking at this stuff and was wondering am I on the right...
Does anybody know if you can remove the air pump without damaging the engine? I heard that the air pump helps oil the engine. I have looked all over the place and can't seem to get a straight anwer.