Wingtips, then.
Type: Posts; User: joeg
Wingtips, then.
I wouldn't go with two because they are not a 100% reliable bit if kit. Kill switches do fail and it has happened to me twice. I would not like to double the chances of a failure. When they do...
Proceed to ebay...lots of shoes (new and used)
I use welding cable.
Heck, the more the merrier. I typically run in very mixed groups and have a lot of fun.
That is the idea.
Quarter and wheelhouse OEM NOS search a problem? Doors and fenders should be EZ (maybe consider pre-painting spares).
Agreed. Big deal for ITC in Ohio, WNY and MI too.
We are more or less home-based at Nelson Ledges, so there can be a lot of bad knocks from those "not-in-the know" on account of that.
Yes!
yes
Thanks, Jimbo
The more the merrier!
Hand-held or system?
I had thought a system requires a horizontal bottle mounting (per instructions?) so it functions correctly.
If a handheld, check out the roll bar style mounts for a...
Slightly Higher than for sheet metal
Copper plate back-up is your friend.
Heck..don't fret; everyone blows holes through sheet metal.
I will usually rosette a floor plate in addition to perimeter welding it.
Whatever the market would bear...I know some folks that will not use sets older than 11(s).
Others? They are OK. About 40% of retail is a good starting place.
Supposedly changes exhaust tone...may help with a rotary.
If you are feeling flush, you might want to spec out Inconel.
Either way, fabrication is a challenge.
An Accusump will not help raise pressure, but works to stabilize what you have.
They have been around a long time and are very well thought of. All my race cars have them. In and of themselves,...
Online; try Eastwood
3M™ Welding and Spark Deflection Paper, 05916
The only time I have seen an inner boot failure was on account of my motor/tranny mount coming apart.
Ugh!!
But actually, the car ran OK in such state.
Don't obsess about it. The ruling may have been a bit harsh but not completely crazy. To the judge of the start, you pulled out of line a bit while the camera car pulled out an egregious amount....
Great Idea for using up older generation Miatae.
I "massaged" the tunnel on my last build with some nice surgical moves.
You would have to go below the floor plane with that frame in order to get the driver positioned lower--unless we are dealing with a jockey-sized driver.
Kind of tough to figure out, but when in...