Truck has been recovered , however car and trailer are still missing. I have heard unconfirmed reports that the trailer was seen yesterday in the Kamloops area. It is a white 26-28ft enclosed trailer...
Type: Posts; User: Gord Galloway
Truck has been recovered , however car and trailer are still missing. I have heard unconfirmed reports that the trailer was seen yesterday in the Kamloops area. It is a white 26-28ft enclosed trailer...
Everyone please keep your eyes out for a stolen 1997 Integra race car with the #38 and WCMA/CACC bagdes on it. It is White with Yellow accents and is fairly distiguishable (if still in one piece)It...
I am not sure about the issue of legality for using the canadian doors however as long as you fell within your minimum weight why would this be a problem?
------------------
Gordon Galloway...
I will admit I run Premium in my cars. 2 reasons: 1-I have advanced my timing as much as the distributor slots will allow, 2-In the event of an overheat situation or a slightly lean burn situation...
BIG HEADS UP!!!!!!
One of the Civic's were running had a Phantom grip LSD...I don't ever recommend anyone running these for a road course circuit and here's why. We were 46 laps into the roughly 60...
Oh and by the way make sure you get the studs for a 3.2 TL and not a 2.5 TL as they are different and the 2.5 studs are as long as a standard Civic stud.
------------------
Gordon Galloway
Honda...
I can personally guarentee that the 96-98 3.2TL studs will fit ANY Honda. The bonus is here..(and you didn't hear this from me!) 96-98 3.2TL had a recall due to a poor splash shield/bearing seal...
Just to specify a little more...96-98 3.2TL studs as the 2.5TL studs are shorter. The 3.2TL studs work really good and fit exactly the same as the factory stud.
------------------
Gordon Galloway...
Without using the dust seals you are risking dirt and goo getting into the seal which in turn will cause it to leak and may cause a catastruphic failure. If you are melting seals are you running...
Jon, be carefull about painting the calipers as a lot of times the paint interfers with heat transfer and causes fluid to boil easier. just my thoughts.
------------------
Gordon Galloway
Honda...
Just to let you know...pre 91 ish Acura and Honda's used a LED in the computer, all you have to do is peel back the carpet on the passenger side firewall, turn the key on and count the flashes, 1...
True Jon, the car definitly has stiffer spring rates. however some of the places I was applying power would definitly without a question cause the inner wheel to spin and cause brutal understeer...
I had the opportunity to drive a similarily prepared car this weekend except that it had a quaife...WOW what a difference!!!! You don't realize what differnce it makes untill you try one. I have...
I just landed a cool sponsor on the weekend...He does realtime programming of ECU's while they are on the Dyno , and this dyno also incorporates some kind of whizzy exhaust gas analyzer so that A/F...
Check all the connections to you instument panel and also the printed circuit board of the IP as I have seen the odd one that has a bad connection that when it heats up there is too much resistance...
I tried and tried and tried but I could not get that week off work...hopefully I can do the september race instead. Likewise don't forget that if you want to come to Calgary the Aug 23,24,25 weekend...
If you don't mind me asking Dave, what would be involved with this chip burning? You can e-mail me at [email protected]
Unfortunately we have already discussed the phantom grip and have determined that it burns out diffs and doesn't work that good due to the fact that the spider gears in a factory diff really weren't...
Just a thought, What advantage is a 2.25-2.5" pipe if your header collector is only 2". theroetically the exhaust will be only as good as the section with the smallest diameter. And besides a 2"...
There is a very good Japanese spec only parts importer here where I live and this friend of mine had no problem getting this Trans. and it was in the neighborhood of $400 canadian. Having said this I...
When in doubt put in a bigger fuse and look for the smoke!!!! That's too bad to hear that it smoked a little to much. Why did it smoke this bad? Did you put in a bigger fuse?and the next thing is is...
A friend of mine just finished putting a SOHC ZC motor into his 89 civic (street car) and complete drive train. He claims that it uses the same series of tranny however it has a factory LSD. My...
Have you replaced &/or checked all of the bulbs? I have seen on several cars in the past where the lead contacts on the end of the bulb actaully mushroom so bad that they are either touching or with...
I'm curious as well as to where these hubs break? As far as the Aug race it is almost finalized....looks like it's gonna be a big one. We are combining the big Vintage on the Praries race weekend...
Unfortunately I already bought the proper ones and put them in today...And unfortunately it's not as simple for me to just order the Acura part and if not right send it back as since I work there if...