Search:

2door 325e roller, includes repaired rust holes in floor.

Hanover PA area.

Bring your trailer.

Whoops, it's an 85 E30. Sorry.

Also, I found out that the rear end in the proposed donor car is bad so it doesn't matter what ratio it is. (And the guy pulled the motor/trans and is sticking in a...

I have one of those special "Zundfolge 1324" motors in my 2002.

What rear end ratio should be in a 325i Automatic? 3.90 or 4.10?

(I suppose I could look at the tag but it's too hostile yet to crawl under a car. MAybe in a couple weeks...)

For that matter I...

(It's for a tow vehicle motor)

There was a show on Speed last week dealing with rebuilding an engine...I couldn't hang on and watch the entire thing but they mentioned "bronze titanium Coatings" for engine and gearbox.
Coatings...

Tim: Thanks ever so much, at the present time I am out of room for cars and my garage got flooded from Ivan, with a 2002 and two E30s inside. All were stripped, and the 325s were awaiting cages,...

Thanks so much.

Anybody know what rear is supposed to be in a 318i ? Car is approx an 85.
Thanks

...Actually I went over to the Ground Control site and looked at their setup, it seems that their tube is a lot shorter than the tube I have. Any feedback will still be appreciated. Thanks.

I'm preparing a '87 325. I'm going to install front coilovers, and have removed the spring perches. I've ground down the part where the perch was welded to the strut tube and a very small ridge...