Starting problems part III

Thanks to all those folks that helped with my RX-7 starting issues, Guess what?????????????
The MSD Ignition was bad, put new MSD in car, car started and turned over immediately, ran great (less filling?).

What an ordeal, I still plan to acquire a stock ignition and keep on hand, MSD went in in 10 minutes, will get old one sent back to MSD and looked at. IT was mounted upside down, the instructions state you can mount them any way................BUT UPSIDE DOWN!!!!!!!!!!!!!!!,
Thanks again, Johhny R.

I KNEW it was the ignition!

Kidding...tho I was suspicious when you described the spark.

Glad it's sorted out.

Now go racing!

------------------
Jake Gulick
CarriageHouse Motorsports
ITA 57 RX-7
New England Region
[email protected]

Johnny, I feel great knowing the issue is past. Thanks for the feedback.

Have Fun http://ITForum.ImprovedTouring.com/wink.gif
David

[This message has been edited by ddewhurst (edited May 13, 2005).]

Good Job!! While you're shipping it back to MSD, if it's just a 6a, have them convert it to a 6d and then you can run a rev limiter.

I learned this AFTER I got my 6a back from them.

------------------
Scott Rhea
It's not what you build...
it's how you build it
http://www.izzyscustomcages.com/images/IzysLgoSm.jpg
Izzy's Custom Cages