PDA

View Full Version : Windshield wiper hotwire



pitbull113
09-01-2014, 09:41 AM
I'm trying to control the wipers on my '94 Miata with a toggle switch. I thought I marked the correct connector when I removed the stalk but now I can't seem to figure out which wires to use. Of course the stalk is gone so that's no help. I'd prefer not to run new wiring all the way to the wiper motor. Any help will be much appreciated.

Greg Amy
09-01-2014, 10:04 AM
Glossing over the fact that this may be a non-compliant modification for Improved Touring...don't you have the required factory shop manual with wiring diagrams?

pitbull113
09-01-2014, 10:17 AM
9c. Gauges and instruments may be added, replaced, or removed.
They may be installed in the original instrument(s) location
using a mounting plate(s), or any other location using a secure
method of attachment. Other than modifications made to
mount instruments and provide for roll cage installation, the
remainder of the dash “board” or panel shall remain intact.
Switches to activate the ignition, the lights, the windshield
wipers, the starter and other accessories located within the
passenger compartment may be replaced and their location
changed.
Yes I have the fsm but apparently I'm wiring schematic challenged.