15x6 rims

[BILL]

I'm looking for a source for 15x6, 4x108 rims for my ITB mustang

[Chip42]

This wont help Bill right now, but...

We (TrackSpeed) are soon to recieve a shipment of D-Force "CR6" wheels designed for the ITB crowd's desire for just such a wheel. they are based on the d-Force spec miata wheel but modified to 15x6, 4x100, 35mm offset, 67mm center bore, weigh right at 12 lbs plus/minus, and cost $115. if there is sufficient interest from the foxstangs, audis, 928's, and fiesta's of the world, we may make a later run with 108mm bolt circle, or you could try enlarging the lug holes but I can't recomend the latter.

for anyone else interested, contact me or you can also get them through Phil's. I have no objections to starting a 108mm order if enough interest is shown, so speak up!

[ajmr2]

Hey Chip. Can you link to a photo of these?

[Knestis]

If I were talking Mustang, I'd look into something like Ron Earp used on his ITS V6. Go see what's available in stock car land.

K

[JeffYoung]

Ron's are 15X7 but I think the company (Spinwerks) will basically make anything you ask them too.

[Ron Earp]

Yes, Spinwerks will do anything from 3" bolt circle out to a 6" bolt circle, four, five, and six lug providing they all fit. The wheels are reasonably priced around $210 to $240 each, weight 11.2 lbs (for the 15x7s) and the 15x6 should be a tiny bit less.

TrackSpeed sounds like a much less expensive and almost as light option if they'll make the four on 108 setup.

[billf]

BILL,

Another option is to use light weight 13X6 Steel wheels (Weld, etc) that are selling for $50-80 each (U.S. as I see you're in Canada). They are very light, very cheep, and can be had in a variety of off-sets. And, they clear any brakes you have on the Mustang. Overall diameter of the 13in tire is slightly smaller than the 14in race tire. I was never able to find light, cheep 14in wheels, without going to the money levels of Ron Earp.

I've done it. I believe I got mine thru Summit.

Good racing.

Bill