View Full Version : heim joint rod ends for mk1
Hi all.
Can anyone direct me to a supplier, or provide the diameter/thread pitches for mk1 steering racks?
Im working way up in northern Canada until late next week, so I can't measure whats on the car, and Im running out of time for the next race.
Any help much appreciated.
Thanks!
Yukon Johnny
VWralley
06-08-2010, 11:28 AM
Jerod at scch-heads makes a bolt in solution that is a pretty good deal. comes with new tie rods and also the sherical ends..
http://scch-heads.com/images/parts/b%20steer%201123.JPG
I actually have a pair of these in my tool box that i ended up not using, I would probably sell em if you were intereted in a complete setup instead of just ends
Knestis
06-08-2010, 04:52 PM
Very nice! Not legal for IT but still, very nice... :)
K
Bill Miller
06-21-2010, 10:56 PM
I've got essentially that same setup on my HP Rabbit. You need to through-bore the knuckle to remove the taper for the stock tie-rod end.
Thanks!
I'll look into this asap.
John
Joe Camilleri
06-23-2010, 10:45 PM
http://www.pmwltd.com/
PMW have a nicely made kit to flip over your stock tie rod ends. You still have to drill out the steering arms to fit.
VWralley
07-08-2010, 01:16 PM
I have had the PWM kit on my rabbit for about 2 years now, great kit for the price. We also run it on our SPU road race car and have had no issues to speak of
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.