PDA

View Full Version : first gen extended wheel studs



zzxracer
08-10-2009, 08:46 AM
looking for a outlet which sells extended wheel studs for first gen (1983) rx-7's...these must be screwed in...hub and rotor are one...they will have hex/allen drive on outer end to turn them into hub...looking for 3" inch long of possible...12x1.5mm threads...thanks..

dtmracing
08-10-2009, 10:20 AM
last I knew Mazdaspeed sold 'em. That's where I got mine. Don't forget the Red Loc-tite!

lateapex911
08-10-2009, 10:51 AM
Turner Motorsports has them, as does Vorslag, where I got mine.

dickita15
08-10-2009, 02:53 PM
Bildon has them too.

dick elliott
08-10-2009, 03:57 PM
7's only too. And none of them screw in. Their all press fit. Just like stock.

rx7chris
08-10-2009, 04:26 PM
1st gen 7's used lug bolts to hold the wheel on. So the screw in ones are required. Used to get mine from mazda motorsports.

dickita15
08-10-2009, 05:37 PM
Chris is right. The Mazda comp ones are not very long, 2 ¼ if I remember right. I used to get mine (2 ¾ I think) from a company at Sears Point but they don’t have them anymore. Fortunately the German cars use the same size.

zzxracer
08-12-2009, 07:05 AM
thanks to everyone for the info!!!!!!