View Full Version : DIY tranny rebuild
rsx858
04-28-2009, 12:27 PM
So i want to learn how to rebuild the trans on my second gen... such a weak link in the drive train i figure there is a lot of money to be saved by doing it myself. I have never cracked a trans open before but i think i can handle it.
-Any suggestions on literature or instuctional books / vids that i should get?
-what special tools and or parts should i get if i plan on doing this regualrly?
Thanks
racingralph
04-29-2009, 03:43 PM
a madza factory repair/service manual should help . a list of tools needed , i'm told. ralph
rsx858
04-29-2009, 05:07 PM
the factory manuals pretty expensive right? Are these trannys basic enough that i could learn with a generic how to book for manual transmissions
Would get a manual. Search eBay--usually cheap.
If you do not have a hydraulic press and bearing separator, as well as assorted seal drivers and clip tools, you may be tackling too much of a project.
Redshift
04-29-2009, 06:55 PM
Assuming you have some paper for your printer (or can work from a screen) why buy a printed factory service manual?
PDFs are abundantly available:
(From RX7Club FAQ)
(86-88 only)
http://www.teamfc3s.org/main/factory...ual/1986_1988/ (http://www.teamfc3s.org/main/factory_service_manual/1986_1988/)
and (89-91 only)
http://www.teamfc3s.org/main/factory...ual/1989_1991/ (http://www.teamfc3s.org/main/factory_service_manual/1989_1991/)
S5 Wiring Diagrams:
http://www.rx7club.com/forum/showthread.php?t=530860
I've never cracked a transmission before, but I pulled a few of mine apart, and made some minor repairs (replacing pins etc.) and diagnosed bigger problems without too much trouble using the FSM.
rsx858
04-29-2009, 08:56 PM
great find!
Thanks
Redshift
04-29-2009, 10:00 PM
Happy to help. I have some well thumbed copies in my garage.
Don't own an RX7 without a copy of the FSM!
Greg Amy
04-29-2009, 10:10 PM
Don't own an RX7 without a copy of the FSM!
Especially since having a FSM is required by the Improved Touring rules...
;)
ulfelder
04-30-2009, 07:04 AM
There's also the option of treating trannies as a disposable item. Buy 'em (at the junkyard), race 'em, break 'em, replace 'em, repeat process. This may be cheaper, and it's certainly easier.
One other thing: pals give me grief for my granny shifts, but my trannies last much longer than most RX-7 guys'. Half a pause on the 2-3 shift costs what, a tenth of a second? But my trannies always last a season or more. :D
Steve
lateapex911
04-30-2009, 08:32 AM
I considered building my own, but when i looked that the time, the economics and the risk, it made no sense. It would take me a number of builds for the $ aspect to be justified.
I used Bill at comp Gears outside of Boston (thanks to Andy and Flatout for the recommendation) and it was about a thousand for TWO transmissions. yea, and I can TRUST his work!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.