View Full Version : 2nd gen Koni rear shock studs - help!
hakeem
06-04-2008, 03:08 PM
I need a pair of Koni compatible rear shock mounting studs. Does anyone have any? Help please!
[email protected]
seckerich
06-04-2008, 03:39 PM
Just pull out the stock ones and have them turned down on a lathe. Should be a machine shop near you. Just turn down far enough in for the width of the bushing. I suggest getting the proper wrench for the mount studs or they will round off easy. They are usually really tight.
Eagle7
06-04-2008, 06:52 PM
If you buy some, make sure to get the right ones. Different Koni shocks take different studs.
Chris Wire
06-06-2008, 11:40 AM
I took a different route. I removed the bushing from the bottom of the shocks and had some Delrin bushings made with the proper size bolt hole. I left a lip on the outside to allow the bushing to stay located, thus eliminating any shift.
I might be able to fire off a pic this weekend.
Chris Wire
06-06-2008, 10:08 PM
Follow-up pic...sorry for the poor pic quality, it was a rush job.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.