27 mm rear sway bar for 91 CRX

[ITC007]

Anyone have one for sale or know where I might be able to find one?

[R2 Racing]

Anyone have one for sale or know where I might be able to find one?
[/b]
Does a CRX even need a 27mm rear sway bar? Good lord, I hope you're not talking about a solid 27mm bar. :o

What was on the car before? Have you got the chance to drive it yet?

[Domino]

Just an aside...why go with a 27mm? If you need something that large then you really need stiffer springs. I have a 22mm (7/8") Suspension Techniques adjustable and it's more then enough. Got it from OPM a while back. 22mm is much easier to come by.

[ITC007]

it was passed on that that is the way to go, but it could be cheaper to run different springs. I have the stock SI bar on it right now.

[R2 Racing]

I'll agree with Mark here. Get the 22mm Suspension Techniques bar as that should be more than enough for a CRX - plus it'll be a direct bolt in application. (I use to have one custom mounted on my Integra at one time and it worked ok on that car, and it has a much longer wheelbase. Too bad, I just sold it.) If you need more than that, than you need to be looking at springs.

[iagreen]

It's no 27, but this is the 24 I run.

Progress 24mm RR bar (http://progressauto.com/store/product_info.php?cPath=57&products_id=410)

[Xian]

Just an aside...why go with a 27mm? If you need something that large then you really need stiffer springs. I have a 22mm (7/8") Suspension Techniques adjustable and it's more then enough. Got it from OPM a while back. 22mm is much easier to come by.
[/b]
x2

If you need more rear roll stiffness than a 22mm bar can give you then I'd suggest going higher in rear spring rate.

Christian

[H5Civic]

I have both a 22mm ST bar as well as a 24mm Progress bar, both of which are no longer being used, either of which I'd be willing to sell.

PM me or shoot me an email, [email protected].

Regards,

Sam

[reddog_es22]

New ASR bar undergoing testing ...

http://www.rr-ax.com/bbs/forums/thread-vie...osts=12&start=1 (http://www.rr-ax.com/bbs/forums/thread-view.asp?tid=3500&posts=12&start=1)

[ITC007]

Checking into all of this, and reserching some spring rates.
Thank you all for your time.