anrkii
02-27-2007, 12:56 PM
while im updating my cage, I figured that I would go ahead and add a dash bar.
the fit is very snug against the dash, so close, in fact that I can only weld about 3/4 of the way around. Can I get away with this because its an optional brace? If not , what can I do... can I hack the corners of the dash off so I can get in there?
Any idears?
the fit is very snug against the dash, so close, in fact that I can only weld about 3/4 of the way around. Can I get away with this because its an optional brace? If not , what can I do... can I hack the corners of the dash off so I can get in there?
Any idears?