Rear bushing install

[Joe Camilleri]

I'm now at the point of installing the axle beam on my Scirocco. I have a set of Delrin bushings from BSI and I'm puzzling over how to install them.

the bronze inner bushing is wider than the Delrin when placed in the mounting bracket. Do I space this to the inside and back up the Delrin with washers of the same ID as the OD of the bronze bushing? Do I use the large stock washer on the outside to capture the Delrin bushing?

If anyone can advise or email me a pic of their installation, I would be grateful.

Thanks.

[JamesB]

My car has delrin rear bushings but I did not install it. However the car is 1.5 hours away from me to snap some pictures. I will check my PC tonight and see if I ever snapped any before and post them.