PDA

View Full Version : Transmission bearing plate



ddewhurst
08-23-2004, 08:42 AM
Have any of you ever eliminated wear loosness in the three shift rod holes in the transmission bearing plate holes that the shift rods slide in ? What was the results ?

Do you do anything about the worn out teeth on the gear teeth on the reverse transmission clutch slider ?

Have Fun http://Forum.ImprovedTouring.com/it/wink.gif
David

benracin
08-23-2004, 10:22 AM
Putting together a trans David? The transmission of mine that never caused any probs finally had one and lost 5th gear on Friday's pratice at Brainerd. Yuck. John and I will be attempting to make uber transmission out of my spares now. Hope it's possible! How's the car?

ddewhurst
08-23-2004, 02:03 PM
***How's the car?***

Ben, just trying to get the thing up to some specific standard so the you & Bill don't have a whole lot of room to do that braging thing. From my one time out doing a Midwestern Counsel race practice sessions with the new stuff the shift points come a bunch quicker. http://Forum.ImprovedTouring.com/it/biggrin.gif I think I kind of hit a wall this year & could care less if I race or not. & at the same time I need to get two races in before the snow flys. Shucks, I forgot I'm retired I can go south after the snow flys.

Have Fun http://Forum.ImprovedTouring.com/it/wink.gif
David