View Full Version : 1st Gen GSL-SE Dyno Readings

Allen Brown
05-17-2002, 12:06 PM
I've seen a few posts about HP for the 7, but nothing for a ITS setup on the SE.

Yes I know the SE is down and out compared to the 2nd Gen. But that's what I have....

Last year I was only able to get (at the RW) 140hp @ 6800rpm, with 95% hp from 6000 to 7800rpm.
This is with factory ignition system, dual 2" pipes (over rear axle) merging into 3" in/out Dynomax super turbo muffler. Still factory airbox w/ K& N filter. I haven't installed a fuel pressure reg yet...Will this help out? I'm looking to add a MSD box to try to help out the factory ignition system.

Are there any other SE's out there that are ITS and are willing to share HP readings? And w/o going into alot of detail, any suggestions to try to wring out a few more hp?


05-17-2002, 05:20 PM
Allen email me off board


Allen Brown
05-17-2002, 05:26 PM
Originally posted by Dewey:
Allen email me off board


Dewey...What's your email address?


05-17-2002, 11:28 PM
Come on! Why the secrets??? Put your numbers out there!!!


05-18-2002, 12:24 AM
No secrets just though it would be quicker to talk off line.
Max hp 159.7 at 7300rpm
MaxTorque130.6 pretty flat from 5500rpm to 6400rpm
This is what worked on my motorcould and will be different on yours.
1. Freshly blueprinted injectors
2. 20 timing
3. 56 lbs fuel pressure
4. Brand new housings and rotors

Allen Brown
05-18-2002, 08:32 PM
Thanks for some of your info....There gives me some hope.

My email is [email protected]

My engine was rebuilt 3 years ago, but not new housings. Talk to you later.