I need offset bushings for the front of a 2g CRX

K

Kazoo

New member
As the subject reads, I need to get some bushings to adjust out some camber in the front of a second generation CRX. I remember seeing posts a while ago where people referred to getting a specific part number from NAPA...but unfortunately, I wasn't in need of them at that time and didn't note the number.

What are you guys using? ...and where did you get them?

Thanks.
 
Since you have a car for ITA, the rules require that you use bushings that are eccentric. With this in mind for the front end-Specialty Products has that covered for you. The Ingalls slide and that is not permitted. Take a look at www.specprod.com. If you know how much correction you want, you can select parts accordingly. For additional help give Specialty a call - they have really good tech people.
For the rear end you are only allowed to shim the control arm and several companies have kits for that. Where can you buy kits-I call Ultra Performance in Tucson and get very good pricing and delivery.
 
So.... are offset balljoints LEGAL for IT?

Some of the other products shown at the Specialty Product site look good, and would be legal, for sure.

Not sure about hte aluminum lower control arms, though....

Jon
 
>So.... are offset balljoints LEGAL for IT?<

No they aren't. We're only allowed eccentric bushings and shims to adjust things...
Its too bad, because some of the stuff sold for these cars looks pretty nice...but, we're just stuck using bushings.
 
RACER10:
Thanks for the information, but I tried calling NAPA with that number and they couldn't do anything with it. Do you have any more information about it? (like what it's sold for, etc....if it is another manufacturer's # that NAPA sells, etc.)

Thanks.
 
You must log in or register to reply here.
Back
Top