PDA

View Full Version : Looking for non-A/C crank pulley and w/p pulley



Bill Miller
08-10-2002, 01:19 PM
I'm building a motor for a Mk I Scirocco street car, and I'm going to need this set of pulleys. Figured I'd see if any of the VW racers out there might have a spare set laying around. Also, I need a rear tranny mounting bracket, the one that goes between the rear motor mount and the tranny. Has a flat plate w/ 2 holes on one side and a curved plate w/ 3 holes on the other side (the on that attaches to the tranny).

------------------
MARRS #25 ITB Rabbit GTI
SCCA 279608

Scirocco#28
08-12-2002, 11:15 AM
I can't help ya unless the bracket is the same as a MKII rocco. On the other hand, I have a question for you if you could email me at [email protected]

Thanks
Steve

jnathan
08-16-2002, 04:31 PM
Not sure if someone had one but I am know I have a crank pulley and am pretty sure I have an extra water pump pulley for a 1.8L 8v. If this will work and you still need them, e-mail your shipping address to [email protected] and I will send them on Monday.

Jason

Bill Miller
08-16-2002, 10:56 PM
Steve,

I'm pretty sure the bracket is the same.

Jason,

Email sent! Thanks!!!

------------------
MARRS #25 ITB Rabbit GTI
SCCA 279608